Fujitsu PRIMERGY BX900 - Page 660

© 2011 Fujitsu Technology Solutions
658
This command sets the Force Protocol Version parameter to a new value on this interface. This command
only works on dot1d mode.
Syntax
spanning-tree loopguard
no spanning-tree loopguard
no - This command sets the Force Protocol Version parameter to the default value, that is Disabled.
Default Setting
Disabled
Command Mode
Interface Config
This command sets the Guard Mode parameter to a new value on this interface. This command only works
on dot1d mode.
Syntax
spanning-tree guard {loop|none|root}
no spanning-tree guard
loop –This command sets the Guard Mode to loop guard on this interface.
none –This command sets the Guard Mode to none.
root – This command sets the Guard Mode to root guard on this interface.
no - This command sets the Guard Mode to the default value, that is none.
Default Setting
none
Command Mode
Interface Config