© 2011 Fujitsu Technology Solutions
665
If the ‘port-priority’ token is specified, this command sets the priority for this port within a specific multiple
spanning tree instance or the common and internal spanning tree instance, depending on the <0-4094>
parameter. The port-priority value is a number in the range of 0 to 240 in increments of 16.
Syntax
spanning-tree mst <0-4094> port-priority <0-240>
no spanning-tree mst <0-4094> port-priority
<0-4094> - multiple spanning tree instance ID.
no - This command sets the Port Priority for this port within the multiple spanning tree instance or in
the common and internal spanning tree to the respective default values. If the <0-4094> parameter
corresponds to an existing multiple spanning tree instance, then the configurations are done for that
multiple spanning tree instance. If however, 0 (defined as the default CIST ID) is passed as the
<0-4094>, then the configurations are performed for the common and internal spanning tree instance.
If the ‘port-priority’ token is specified, this command sets the priority for this port within a specific
multiple spanning tree instance or the common and internal spanning tree instance, depending on the
<0-4094> parameter, to the default value, that is, 128.
Default Setting
port-priorty : 128
Command Mode
Interface Config
To Next Page
Loading...
