Fujitsu PRIMERGY BX900 - Page 695

© 2011 Fujitsu Technology Solutions
693
10.15.2.5 sntp unicast client poll-timeout
This command will set the poll timeout for SNTP unicast clients in seconds.
Syntax
sntp unicast client poll-timeout <poll-timeout>
no sntp unicast client poll-timeout
< poll-timeout > - Polling timeout in seconds. The range is 1 to 30.
no - This command will reset the poll timeout for SNTP unicast clients to its default value.
Default Setting
The default value is 5.
Command Mode
Global Config
10.15.2.6 sntp unicast client poll-retry
This command will set the poll retry for SNTP unicast clients in seconds.
Syntax
sntp unicast client poll-retry <poll-retry>
no sntp unicast client poll-retry
< poll-retry> - Polling retry in seconds. The range is 0 to 10.
no - This command will reset the poll retry for SNTP unicast clients to its default value.
Default Setting
The default value is 1.
Command Mode
Global Config