© 2011 Fujitsu Technology Solutions
744
10.17.2.10 match ip precedence
This command adds to the specified class definition a match condition based on the value of the IP
Precedence field in a packet, which is defined as the high-order three bits of the Service Type octet in the
IP header (the low-order five bits are not checked). The precedence value is an integer from 0 to 7.
Syntax
match ip precedence <0-7>
Note: The ip dscp, ip precedence, and ip tos match conditions are alternative ways to specify a match
criterion for the same Service Type field in the IP header, but with a slightly different user notation.
Note: To specify a match on all Precedence values, use the match [not] ip tos <tosbits> <tosmask>
command with <tosbits> set to 0 and <tosmask> set to 1F (hex).
Default
None
Command Mode
Class-Map Config
To Next Page
Loading...
