Fujitsu PRIMERGY BX900 - Page 748

© 2011 Fujitsu Technology Solutions
746
10.17.2.12 match protocol
This command adds to the specified class definition a match condition based on the value of the IP
Protocol field in a packet using a single keyword notation or a numeric value notation.
Syntax
match protocol {<protocol-name> | <0-255>}
<protocol-name> is one of the supported protocol name keywords. The currently supported values
are: icmp, igmp, ip, tcp, udp. Note that a value of ip is interpreted to match all protocol number
values. To specify the match condition using a numeric value notation, the protocol number is a
standard value assigned by IANA and is interpreted as an integer from 0 to 255.
Note: This command does not validate the protocol number value against the current list defined by IANA.
Default
None
Command Mode
Class-Map Config
10.17.2.13 match srcip
This command adds to the specified class definition a match condition based on the source IP address of
a packet.
Syntax
match srcip <ipaddr> <ipmask>
<ipaddr> specifies an IP address.
<ipmask> specifies an IP address bit mask; note that although it resembles a standard subnet mask,
this bit mask need not be contiguous.
Default
None
Command Mode
Class-Map Config