Fukuda DS-8500 - Initial Settings

5-1
Chapter 5 Initial Settings Initial Settings
Chapter 5 Initial Settings
Initial Settings
This section explains about the "Initial Settings" menu.
Under "Initial Settings" menu, there are 7 setup categories which are Alarm, Measurement, User I/F, External
Device, System, User Mode Registration, and Administrator Setup.
Description for Each Category
Category Subcategory Description
Alarm - Alarm-related settings, alarm indicator settings, etc.
Measurement User Label User label settings for BP and TEMP
Unit Measurement unit settings for CO
2
, BP, CVP, TEMP, ST, Height/Weight
Other Other settings such as arrhythmia analysis filter, etc.
User I/F Display/Print Display and print settings such as date format, BP alarm limit increment, etc.
Power ON/ Discharge Settings such as backup status at "Power ON" and "Discharge", etc.
Menu Key display settings for Menu screen
Key Mask Key mask settings for unnecessary keys
Remote Control Settings for remote control
Operation Settings for mouse operation, window minimizing settings, etc.
External Device Main Unit Port/HP-800 Settings for external device connectors such as serial port, Status II connector,
U-Link connector.
Magnetic Card Reader Settings for magnetic card reader
Network Network settings for laser printer.
Status Output Settings for alarm output.
Analog Output Settings for analog output, synchronized signal output.
System DS-LAN Wired network settings such as Room ID, Bed ID.
Telemeter Telemetry settings such as telemetry channel, transmitting waveform, etc.
Unit/Module Settings for multiamplifier connector, SpO
2
channel.
Other AC filter, Extended Display Unit, Data Transfer, Numeric Data External Output
User Mode
Registration
- Registration of 9 main modes and 6 sub modes for monitoring.
Registration of 6 modes for extended display unit.
Administrator
Setup
Key Lock Settings of key lock level for display and setting
Password Setup Settings for password and administrator