iv
Safety Precautions for Safe Operation of Medical Electrical Equipment
Precautions for Safe Operation of Medical Electrical Equipment
Users should have a thorough knowledge of the operation before using this system.
Precautions about the Location of Installation and Storage of the Equipment
Do not install or store in an area where the unit will be subject to splashing water.
Do not install or store in an area where the environmental conditions, such as atmospheric pressure,
temperature, humidity, ventilation, sunlight, dust, sodium, sulfur, will adversely affect the equipment.
Place the equipment on a stable surface where there is no inclination, vibration, or shock (including during
transportation).
Do not install or store in an area where chemicals are stored or gases are evolved.
Verify the power frequency, voltage and allowable current (or power consumption).
Ensure the grounding is proper by connecting the accompanying power cable to the hospital grade outlet.
Do not install the equipment in a location where it is difficult to unplug the power cable.
Precautions Before Using the Equipment
Verify the power voltage.
Check the cable connection and polarity to ensure proper operation of the unit.
Make sure the power system has adequate earth ground.
Ensure that all cables are firmly and safely connected.
Pay special attention when the device is used in conjunction with other equipment as it may cause erroneous
judgment and danger.
Precautions During Using the Equipment
Always observe the equipment and patient to ensure safe operation of the equipment.
If any abnormality is found on the equipment or patient, take appropriate measures such as ceasing operation
of the equipment in the safest way for the patient.
Do not allow the patient to come in contact with the equipment. Also, the operator should not contact the patient
and the equipment at the same time.
On start-up of the system, verify that the start-up tone generates and alarm indicator lights.
For the connectors which are not Type BF, CF applied part, do not touch them and the patient at the same time.
Precautions After Using the Equipment
Unplug all the cables from the patient before turning off the power.
When unplugging the cables, do not apply excessive force by pulling on the cable. Pull from the connector part
Home Key: Displays the home display.
Menu Key: Displays the menu screen.
Previous Display: Displays the previous display.
Symbol Description
To Next Page
Loading...
