8-1
Chapter 8 Cleaning/Disinfecting/Storing After Usage/Handling the Equipment
Chapter 8 Cleaning/Disinfecting/Storing
After Usage/Handling the Equipment
This section explains about how to handle the equipment.
After Using the Equipment
When unplugging the cables, make sure to pull from the connector part of the cable and avoid applying
excessive force.
Clean the equipment, accessories, and cables, and keep them together in one place for next use.
Always check for adequate supply of ECG electrodes, and other disposable accessories. If any shortage is
found, contact your nearest service representative.
Display Unit
The display unit utilizes LED for the backlight. Since this LED deteriorates by the life cycle, the display may
become dark, scintillate, or may not light by the long term use. In such case, contact your nearest service
representative.
Although the LCD utilizes highly accurate picture elements, occasionally, there may be a few pixels which do
not light or constantly light. However, this will not affect monitoring operation.
Due to its material characteristic, the touch panel expands/contracts depending on the temperature/humidity.
When the touch panel is left unused for a while, or when the ambient temperature is low, the surface film of
the touch panel may expand, but this is not an abnormal condition.
This expansion will be reduced in few hours or half a day after the power is turned ON.
The surface of the touch panel is susceptible to scratches, therefore do not scratch or rub it using a hard item.
Storing the Equipment and Recording Paper
This section explains how to store the equipment and recording paper.
Equipment
Store in a place where the equipment will not be exposed to splashing water.
Store in an area where the environmental conditions, such as atmospheric pressure, temperature, sunlight, dust,
sodium, sulfur, will not adversely affect the system.
Store in a level area where the equipment is not exposed to vibration and shock (including during
transportation).
Store in an area which meets the following environmental conditions.
Storage Temperature: -10°C to 60°C/14°F to 140°F
Storage Humidity: 10% to 95% (at 40°C/104°F, non-condensing)
Atmospheric Pressure: 70 kPa to 106 kPa
To Next Page
Loading...
