Fukuda DS-8500 - Chapter 3 Using the CF card; Inserting the CF card; Data Backup;Copy Using the CF Card

3-1
Chapter 3 Using the CF card Inserting the CF card
Chapter 3 Using the CF card
By using the optional CF card (FCF-128: 128MB, FCF-1000: 1GB), backup/copy of the patient data and setup data
can be performed.
By using the optional CF card (FCF-16GA:16GB), full disclosure waveform data can be stored.
Inserting the CF card
CAUTION
 When using the CF card for data transfer, make sure that the power of the main unit is turned
ON before inserting the CF card into the CF card slot.
1Insert the specified CF card into the CF card slot.
Data Backup/Copy Using the CF Card
This section explains about the backup and copy procedure of the setup data using the optional CF card.
Setting all the monitors in the same ward to the same alarm settings and display configuration may take large amount
of time.
However this process can be simplified by performing the setup on one monitor, and copying the data to all the other
monitors using the CF card.
CAUTION
 Turn ON the power of the main unit before inserting the CF card into the CF card slot 1
(CF1).
The CF card slot 1 (CF1) is for data backup, and CF card slot 2 (CF2) is for full disclosure
waveform.
 Use only the specified CF card.
 The CF card formatted for the central monitor full disclosure waveform data cannot be used
on the DS-8500 System.
NOTE
 Cancel the write-protect function before using the CF card.
 If the same card is repeatedly used without formatting, card capacity shortage may occur.
Make sure to format the card before saving the data to the CF card.
REFERENCE
 For details of the data which can be backed up, refer to "Data that can be Backed Up/
Copied".
1Press the [Menu], [Maintenance], [CF Card SD Card] keys.