Name: GE Giraffe OmniBed
Brand: GE
Rating: 4 (1 reviews)

Default Chapter3

Table of Contents3

About this Manual15

Chapter 1: Functional Description29

Chapter 2: Service Checkout39

Chapter 3: Calibration and Maintenance49

Chapter 4: Troubleshooting57

Chapter 5: Repair Procedures99

Canopy Removal for Replacement99
Figure 5-1 Heater Housing Cover and Soffit100
Figure 5-2 Original Seal Parts101
Figure 5-3 Nuts101
Figure 5-4 Access Holes102
Figure 5-5 Canopy, Bracket, and Heater Housing102
Figure 5-6 Two People Needed for this Step103
Servicing the Canopy Seals104
- Figure 5-7 Canopy Seals and Extrusions104
- Figure 5-8 Wedging a Blunt Object to Keep Seal Open105
- Servicing Original Canopy Seals105
- Figure 5-9 Enhanced Seal Parts106
- Figure 5-10 West Side Seal Parts107
- Figure 5-11 Using North Seal to Help Position Washers107
- Figure 5-12 Seal Cross-Section108
- Figure 5-13 North Seal Parts109
- Figure 5-14 Beveled Side of North Spacer Toward Canopy109
- Figure 5-15 Hole Fill Assembly (2X) for Canopies with Six Holes Across North End110
- Figure 5-16 South Seal Parts111
- Figure 5-17 South Corner Parts112
- Figure 5-18 North Corner Parts112
- Figure 5-19 Installing Rail Spacers113
- Figure 5-21 Soffit115
- Figure 5-22 Trimming the Soffit115
- Figure 5-23 Untrimmed and Trimmed Soffit116
- Servicing Enhanced Canopy Seals117
Porthole Door Replacement118
Right Rail Assembly Repair Procedures118
- Removing the Right Upright (Motor Side)118
- Figure 5-24 Disconnecting Heater Door Cable119
- Figure 5-25 Upright Decorative Strips, End Caps, and Wire Covers120
- Figure 5-26 Removing the Lift Motor121
- Figure 5-27 Display Module Disassembly121
- Removing the Left Upright122
- Right Rail Internal Repairs124
- Reassembling the Right Upright128
Left Rail Internal Repairs130
- Removing the Inner Rail Assembly130
- Figure 5-32 Left Inner Rail130
- Replacing the Rail Buoyancy Springs131
- Figure 5-33 Left Rail Springs and Spools131
- Replacing Rollers, Tension Springs, and Cable Carrier Links132
- Reassembling the Left Upright132
- Figure 5-34 Re-Attaching the Upright132
- Replacement of the Left Upright Heater Wire Harness/Cable Carrier Assembly134
Radiant Heater Assembly Repair Procedures139
- Removing the Canopy/Heater Assembly139
  - Figure 5-42 Canopy Alignment140
  - Realigning the Canopy141
- Replacing the Radiant Heater142
- Figure 5-43 Radiant Heater Disassembly142
- Heater Door Spool Assembly144
- Figure 5-44 Heater Door Cable Adjustment144
- Heater Door Cable Adjustment145
- Spring Tube Assembly Replacement146
- Figure 5-45 Securing String to the Spring Tube146
- Figure 5-46 Removal of the Lower M5 Nut147
- Figure 5-47 Dog Point of the Set Screw148
Compartment Air Probe Repairs149
Figure 5-48 Compartment Air Probe Disassembly149
Removing the Upper End Cap Spring150
Figure 5-49 Top Rail End Cap150
Lower Unit Repairs151
- Removing the Chassis Cover with the Storage Drawer in Place151
- Incubator Fan, Fan Motor, and Optical Fan Sensor152
- Figure 5-50 Bed Disassembly152
- Figure 5-51 Heat Sink and Fan153
- Figure 5-52 Fan Motor153
- Incubator Heater Replacement154
- Elevating Base156
- Chassis Replacement157
- Figure 5-54 Chassis Bottom Cover157
- Bed Up/Down Pedal Switch158
- Canopy Pedal Switch158
- Canopy Membrane Switch Replacement158
Bed Tilt Brake Pad Replacement160
Figure 5-55 Replacing the Tilt Brake Pad160
Caster Replacement161
Humidifier Assembly Repairs161
- Tips for Repairing an Old Style Unit162
- Disassembly162
- Figure 5-56 Humidifier Parts163
- Reassembly164
Controller and Display Module Procedures165
- Display Module165
- Figure 5-57 Display Module165
- Probe Panel166
  - Figure 5-58 Probe Panel166
  - Battery167
- Controller Components168
Servo Controlled Oxygen Service Procedures171
- Installing Oxygen Sensors171
- Replacing the Vent Screen171
- Figure 5-60 Installing Sensors171
- Sensor Housing Repairs172
- Valve Housing Repairs174
- Endcap Safety Valve175
- Figure 5-63 Endcap Safety Valve175
- Servo Oxygen Board Repairs176

Chapter 6: Illustrated Parts177

Appendix A: Compartment and Skin Probe Characteristics261

Appendix B: Specifications263

Appendix C: RS-232 Serial Data267

Brand	GE
Model	Giraffe OmniBed
Category	Medical Equipment
Language	English

GE Giraffe OmniBed Service Manual

Table of Contents

Questions and Answers:

GE Giraffe OmniBed Specifications

Related product manuals