GE Giraffe OmniBed - Compartment Air Probe

6.1.8 Compartment Air Probe
1. Compartment air probe@ .............................................6600-1512-700
Probe wire harness@ .......................................................6600-1513-700
2. O-ring ......................................................................................6600-0540-400
3. Humidity sensor assembly*..........................................6600-0784-700
Plug (no humidity sensor installed) ...........................6600-1476-500
4. Retainer ..................................................................................6600-1475-500
5. Break plate ...........................................................................6600-1473-500
6. Screw, M3 x 6 button hd .................................................6600-0706-406
7. Back plate .............................................................................6600-1474-500
8. Flat washer, M3...................................................................6600-0712-402
9. Split ring lock washer ......................................................6600-0713-402
10. Screw, M3 x 20 button hd ..............................................6600-0706-404
11. Screw, M4 button hd ........................................................6600-0706-411
12. Cable clamp .........................................................................6600-0144-400
13. Lock nut, M4 ........................................................................6600-0714-402
Parts not shown
Humidier Calibration Kit* ............................................6600-0048-850
* Unit must be recalibrated using Humidier Calibration Kit whenever sensor is replaced.
@ For earlier units with a compartment air probe cable that disconnected at the probe panel, order service kit 6600-0241-850.
192 6600-0343-000 104 © 2001 by Datex-Ohmeda, Inc.. All rights reserved.
Chapter 6: Illustrated Parts