GE Giraffe OmniBed Service Manual

6.1.5 Humidier
1. Flat washer, M3 x 3.2, ID .5 ............................................6600-0712-402
2. Split ring lock washer, M3 x 3.1, ID .8 ........................6600-0713-402
3. Screw, M3 x 16 Cheese head Phillips ........................6600-1255-404
4. Reservoir switch (included in item 21)
5. Button, reservoir switch .................................................6600-1298-500
6. Top humidier gasket ......................................................6600-1293-500
7. Heater mount ......................................................................6600-1291-500
8. Screw, M3 x 8 Cheese head Phillips,
Teon coated .......................................................................6600-1255-401
9. Ramp block ..........................................................................6600-1777-500
10. Humidier gasket bottom .............................................6600-1294-500
11. Protective insert* ...............................................................6600-1714-500
12. Reservoir seal ......................................................................6600-1495-500
13. Insulating cylinder .............................................................6600-1182-500
14. Bottom bracket ..................................................................6600-1181-500
15. Steam outlet ........................................................................6600-1296-500
16. Silicone tube ........................................................................6600-1780-500
17. Heater sheath .....................................................................6600-1292-500
18. Nut, hex 6 -32 .....................................................................0144-3324-113
19. Split ring lock washer, #6 ...............................................6600-0345-400
20. Safety thermostat assembly ........................................6600-0225-850
21. Add water thermostat assembly
(includes item 4) .................................................................6600-0803-700
22. Humidier heater * ...........................................................6600-0224-850
23. Spacer, .125 ID ....................................................................6600-1779-500
24. Humidier top bracket ....................................................6600-1295-500
25. Star washer, M3 x 3.2 ID .................................................6600-0713-442
26. Screw, M3 x 12 Cheese head Phillips ........................6600-1255-403
27. Humidier reservoir ..........................................................6600-0216-850
Reservoir bottom ...............................................................6600-1493-500
Reservoir lid ..........................................................................6600-1492-500
28. Screw, M3 x 10 skt. hd. ....................................................6600-0707-403
29. Screw, M3 x 10 Cheese hd.
Phillips Teon coated .......................................................6600-1255-402
Parts not shown
Humidier assembly
(includes all parts above except reservoir) .....................6600-0245-850
* Always replace item 11 when replacing item 22.
176 6600-0343-000 104 © 2001 by Datex-Ohmeda, Inc.. All rights reserved.
Chapter 6: Illustrated Parts

GE Giraffe OmniBed Specifications

General

Temperature Control	Yes
Humidity Control	Yes
Servo Humidity Control	Yes
Oxygen Delivery	Yes
Scale	Integrated
Trendelenburg/Reverse Trendelenburg	±12°
Rotating Mattress	No
X-ray Compatibility	Yes
Mobility	Yes, with casters
Category	Incubator
Humidity Range	30% to 95%
Oxygen Hood	Yes
Access Ports	Multiple
Modes	Air Mode, Skin Mode
Power Requirements	100-240V AC, 50/60 Hz