GE Giraffe OmniBed - Figure 5-21 Soffit; Figure 5-22 Trimming the Soffit

12. Realign the canopy as described in section 5.6.1.1.
13. Using a 2.5 mm hex key and four screws, reinstall the heater housing cover, securing it to the heater door
bracket.
14. Trim and reinstall the sot:
a. Remove the north seal.
b. Locate two inside corners of ends of the sot (6600-1461-500).
Figure 5-21 Sot
c. Mark approximately one eighth inch (3mm) by approximately 45º cut line at the inside corners
identied.
d. Cut corners with scissors or tin snips as marked.
1/8”
1/8”
Figure 5-22 Trimming the Sot
Inside corners
© 2001 by Datex-Ohmeda, Inc.. All rights reserved. 6600-0343-000 104 87
Chapter 5: Repair Procedures