INSIDE OF
CANOPY
OUTSIDE OF
CANOPY
Smooth nut
Door support gasket
Door support
M4 splitlock washer
M4x20 buttonhead socket cap screw
Canopy
Spacer washer
West rail
West seal
M4x30 sockethead set screw
cup point
M4x16 buttonhead socket cap screw
Inscribed “W”
Figure 5-10 West Side Seal Parts
NOTE: The east side seal parts are symmetric to the west side seal parts.
4. Install side seal parts on the upside-down canopy. Start by installing all hardware nger-tight:
a. Install the east and west seal guide rails with smooth nuts, spacer washers, lock washers, and screws
from kit, as shown in Figure 5-10. The larger lobe of each rail should be closest to the edge of the
canopy, as shown in Figure 5-12. (This indicates which way is up on each seal.) The rails have “E” and
“W” inscribed for east and west. These letters go toward the heater door cutout end of the canopy.
b. Position the spacer washers between the rail and canopy for assembly.
NOTE: The cutouts in the north seal may be used to help with this positioning of these washers as
shown in the following gure:
Figure 5-11 Using North Seal to Help Position Washers
© 2001 by Datex-Ohmeda, Inc.. All rights reserved. 6600-0343-000 104 79
Chapter 5: Repair Procedures
To Next Page
Loading...
