GE MEDICAL SYSTEMS
DIRECTION 5184024-100, REVISION 5 LOGIQWORKS BASIC SERVICE MANUAL
3-104 Section 3-5 - Configuration
3-5-3-2 General settings
To view and set general LOGIQworks properties:
1.) Select Configuration > Generic... from the Data Selector Menu.
2.) Select the General tab in the Generic Properties dialog.
• Main Window:
- Initial View: Check from the Initial View drop-down list the Worklist View you want
LOGIQworks to display by default when starting. (Default: nothing selected, Local Studies will
be default then)
Figure 3-91 Generic Properties - General Settings
Initial View
Compare patients
To Next Page
Loading...
