GE MEDICAL SYSTEMS
DIRECTION 5184024-100, REVISION 5 LOGIQWORKS BASIC SERVICE MANUAL
3-136 Section 3-5 - Configuration
3-5-4-3 Logging (cont’d)
Set the Maximum Size of the log file to 0 to disable log file truncation. This can be very handy for
troubleshooting.
• Always Flush File after Write: If checked, all logging actions will be written immediately to the log
file. This option will have a serious impact on the performance of RadWorks, so it should not
normally be checked. (Default: not checked)
• Log Pipe: Name of the pipe where logging information is written.
Default: \\.\pipe\AMI2\Connection\Logging
3-5-4-4 Database
This tab contains a collection of settings that are related to database settings for the Connection
Service. The Connection Service uses a database to store destinations and origins, pending and
completed transmission jobs, and information about received studies.
To view the connection database settings:
1.) Select Configuration > Connection Service... from the Data Selector menu.
2.) Select the Database tab from the Connection Service Properties page.
NOTE
Remember: Only change settings if you are an expert!
To Next Page
Loading...
