GE MEDICAL SYSTEMS
DIRECTION 5184024-100, REVISION 5 LOGIQWORKS BASIC SERVICE MANUAL
3-120 Section 3-5 - Configuration
3-5-3-11 Viewing Properties (cont’d)
Use the General tab of the Viewing Properties page to define general properties of the Viewing Section.
• Initial Settings
- Annotation level: Annotation level that is initially used in the Viewing Section.
- Mask State: Set how masks are displayed when entering the Viewing Section.
- Mask Type: Set the type of mask that will appear as the default in the drop-down list at the
top of the Masks tool tab in the Viewing Section.
• Viewing Area
- Monitor groups: Specifies the number of monitor groups you configured. Leave the field
blank to have LOGIQworks display on all monitors.
- Hanging protocol group: Specifies the group to which you want to apply your hanging
protocols.
- Navigation buttons: Click the Config... button to customize where you want to position the
Up, Down, Up Series, Down Series, Previous, Next and Back buttons in the Viewing Section.
- Display Series from Level: Select the default that determines how LOGIQworks should fill
the series area of the Viewing Section when you view multiple studies.
* Select Patients if you want to display the first series of each patient when opening
multiple items for viewing.
* Select Studies if you want to display the first series of each study when opening multiple
items for viewing.
* Select Series if you want to display all the series of the first study, and then all the series
of any remaining studies.
- Show Menu Bar: Check this check box if you want LOGIQworks to display in the Viewing
Section a menu bar with commands for viewing images.
•Data
- Open Priors for viewing Opens for viewing priors associated with a study in the relevant
worklist.
• Image Label
Please refer to the RadWorks 7.0 Installation guide for more information on the viewing properties and
the other configuration tabs on the Viewing Properties page.
To Next Page
