Geely FC - Tire and Wheel; Wheel and Tire System; Inspection

Tire and wheel- wheel and tire system
Tire and wheel
Wheel and tire system
Inspection
1. Check tire.
(a) Check tire is worn and inflation pressure is proper.
Cold tire inflation pressure:
*1 It is used under the condition of speed below 160 km/h.
(b) Check tire run-out with dial indicator.
Tire run-out:
2. Adjust tire position.
Hint: see adjusting position of tire shown in the dia-
gram whether there is spare tire or not.
3. Check wheel balance.
(a) Check and adjust with off-the-car balancing machine.
(b) Check and adjust with in-the-car balancing machine if
necessary.
Unbalanced mass after adjusting:
4. Check axial clearance of front wheel bearing
(see Page 123).
5. Check end surface run-out of front wheel shaft hub
(see Page 123).
6. Check axial clearance of rear wheel bearing
(see Page 129).
7. Check end surface run-out of rear wheel shaft hub
(see Page 129).
8. Check front suspension is loose.
9. Check steering linkage is loose.
10. Check ball joint is loose.
Tire size Front and rear kPa
Front
109