Safety Matters for Attention SC201(1900A/1903A)
temperature beyond the above range.
Relative Humidity: 45%~85%(No dew inside the machine), or the operation
of sewing machine will be affected.
The supply of compressed gas shall be over the consumption required by
the sewing machine. The insufficient supply of compressed gas will lead to
the abnormal action of sewing machine.
In case of thunder, lightning or storm, please turn off the power and pull
plug out the socket. Because these will have influence on the operation of
sewing machine.
Please ask the trained technicians to install the sewing machine.
Don’t connect machine to power supply until the installation is finished.
Otherwise the action of sewing machine may cause personal injury once
the start switch is pressed at that situation by mistake.
When you tilt or erect the head of sewing machine, please use both of your
hand in that operation. And never press the sewing machine with strength.
If the sewing machine loses its balance, it will fall into floor thus causes the
personal injury or mechanical damage.
Grounding is a must.
If the grounding cable is not fixed, it may cause the electric-shock and
mis-operation of machine
The entire cables shall be fixed with a distance at 25mm away from the
moving component at least. By the way, don’t excessively bend or tightly
fixed the cable with nails or clamps, or it may cause the fire or electric
shock.
Please add security cover on the machine head.
This sewing machine can only be used by the trained staff.
This sewing machine has no other usages but the sewing.
When operating the sewing machine, please remember to put on the
glasses. Otherwise, the broken needle will cause the personal injury in case
the needle is broken.
At following circumstances, please cut off the power at once so as to avoid
the personal injury caused by the mis-operation of start switch:
1.Threading on needles; 2. Replacement of needles; 3. The sewing
machine is left unused or beyond supervision
To Next Page
Loading...
