GW Instek GDS-2000E Series - Page 195

APPS
195
2. Press Go Back to return to the
previous menu.
Set Go-NoGo
Actions
1. Press Violating to set what action to
perform when a signal violates the
Go-NoGo conditions.
The waveform stops when the
conditions are violated.
Ignore violations and continue to
monitor the signal. Each violation is
counted.
2. Press Go Back to return to the
previous menu.
Set Go-NoGo
Source
1. Press Compare Source from the
bottom menu to set the Go-NoGo
boundary source.
Sets CH1 as the source.
Sets CH2 as the source.
Sets CH3 as the source.
Sets CH4 as the source.
2. Press Go Back to return to the
previous menu.
Set Boundary
Tolerance
1. To set the Go-NoGo boundary
tolerance, press Reference Mode.