CONFIGURATION
177
Search
The search feature can be used to search for events on the analog
input channels. The events that can be searched for are similar to
the events that are used for the trigger system. The only difference
is that the search feature uses the measurement threshold levels
rather than the trigger level to determine events.
Configuring Search Events
Similar to configuring the trigger system, the
Search events must first be configured before they
can be found.
Luckily the trigger system configuration settings
can also be used for the search events. The types of
searches are listed below. Please note that a full
description of the events can be found in the
Trigger section on page 145.
Number of
search events
Search event markers
Trigger point
To Next Page
Loading...
