GDS-2000E Series User Manual
54
Display All mode
Display All mode shows and updates all items from Voltage and
Time type measurements.
1. Press the Measure key.
2. Press Display All from the bottom
menu.
3. Press Source from the side menu
and choose a measurement source.
4. The results of Voltage and Time type
measurements appear on the display.
To remove the measurement results,
press OFF.
Delay type measurements are not available in this
mode as only one channel is used as the source.
Use the individual measurement mode (page 50)
instead.
To Next Page
Loading...
Need help?
General
