GW Instek GDS-2000E Series - Power up

GDS-2000E Series User Manual
28
Power Up
Requirements
The GDS-2000E accepts line voltages of 100 ~ 240V
at 50 or 60Hz.
Step
1. Connect the power cord to
the rear panel socket.
2. Press the POWER key. The
display becomes active in
~ 30 seconds.
: ON
: OFF
POWER
Note
The GDS-2000E recovers the state right before the
power is turned OFF. The default settings can be
recovered by pressing the Default key on the front
panel. For details, see page 232.