To Next Page

To Previous Page

GDS-2000E Series User Manual

Do not dispose electronic equipment as unsorted

municipal waste. Please use a separate collection

facility or contact the supplier from which this

instrument was purchased.

Safety Guidelines

General

Guideline

CAUTION

 Make sure the BNC input voltage does not

exceed 300Vrms.

 Never connect a hazardous live voltage to the

ground side of the BNC connectors. It might

lead to fire and electric shock.

 Do not place any heavy object on the GDS-

2000E.

 Avoid severe impact or rough handling that

leads to damaging the GDS-2000E.

 Do not discharge static electricity to the GDS-

2000E.

 Use only mating connectors, not bare wires, for

the terminals.

 Do not block the cooling fan opening.

 Do not perform measurement at a power source

or building installation site (Note below).

 Do not disassemble the GDS-2000E unless you

are qualified.

(Measurement categories) EN 61010-1:2010 specifies the

measurement categories and their requirements as follows. The

GDS-2000E falls under category I.

 Measurement category IV is for measurement performed at the

source of low-voltage installation.

 Measurement category III is for measurement performed in the

building installation.

 Measurement category II is for measurement performed on the

circuits directly connected to the low voltage installation.

 Measurement category I is for measurements performed on

circuits not directly connected to Mains.

GW Instek GDS-2000E Series User Manual

Questions and Answers: