GW Instek GSP-9300 - Page 131

ADVANCED OPERATION
129
ADJCH Offset[F4]
Set the adjacent channel
offset.
ADJCH HLimit[F5]
Set the adjacent channel
high limit.
ADJCH LLimit[F5]
Set the adjacent channel
low limit.
2. Repeat the above steps for the other adjacent
channels, if needed.
Move Channels
Up/Down
1. Press
Measure
> Channel Analysis[F1] and press
the following to move to another channel:
Channel Move Up[F5]
Next main channel.
Channel Move
Down[F6]
Previous main channel.
Note
The channel space (CH SPC) parameter
determines where the next main channel is
located.
Remove
Definitions Help
1. Press
Measure
> Channel Analysis[F1]>ACPR
Setup[F1]>Def. Help to toggle the Definitions
Help on or off.