GW Instek GSP-9300 - Page 179

ADVANCED OPERATION
177
5. Press Offset/Limit[F3] to set the offset
parameters:
SelectOffset[F1]
Select which offset to
edit.
[F2]
Toggles the selected
offset on/off.
StartFreq[F3]
Sets the start frequency
of the selected offset.
StopFreq[F4]
Sets the Stop Frequency
of the selected offset.
RBW[F5]
Sets the RBW of the
selected offset.
6. Press More 1/2[F6] to set absolute and relative
level limits and conditions:
Abs Start[F2]
Sets the absolute start
level limit for the
selected offset.
Abs Stop[F3]
Sets the absolute stop
level limit for the
selected offset.
Man: Allows a user-
defined Abs Stop level
Couple: Sets the Abs
Stop level to the Abs
Start level.
Rel Start[F4]
Sets the relative start
level limit for the
selected offset.