GW Instek GSP-9300 - Page 213

ADVANCED OPERATION
211
Other
factor[F4]
Create, edit or select a correction set
to use. This option is useful if a third
party M-field antenna is used. See
page 54 for details on creating a
correction set. This option will not
allow you to simulate the 3m or 10m
radiated emissions.
Limit Standard
3. Press one of the limit standards to show the
limit line for a standard and to start pass/fail
testing. These limit lines should only be used
for when the 3m or 10m correction sets are
used.
EN5502A
Euro commercial standard (10m)
EN5502B
Euro residential standard (3m)
FCC A
American non-residential standard
(10m)
FCC B
American residential standard (3m)
Pass/fail testing will also be performed on the
simulated emissions after each sweep, based on
the standard selected.
Pass:
, with green grid border.
Fail:
, with red grid border.
Display Icon
The alarm icon is shown at the bottom of
the display when a standard is selected.