20
Configuring the server
The following information describes the procedures to configure the server after the server
installation is complete.
Powering on the server
1. Power on the server. For information about the procedures, see "Powering on the server."
2. Verify that the health LED on the front panel is steady green, which indicates that the system is
operating correctly. For more information about the health LED status, see "LEDs and buttons."
Updating firmware
IMPORTANT:
Verify the hardware and software compatibility before firmware upgrade. For information about the
hardware and software compatibility, see the software release notes.
You can update the following firmware from FIST or HDM:
• HDM.
• BIOS.
• CPLD.
For information about the update procedures, see the firmware update guide for the server.
To Next Page
Loading...
