100
10. Power on the server. For more information, see "Powering on the server."
Verifying the installation
Log in to HDM to verify that the GPU module is operating correctly. For more information, see HDM
online help.
Replacing an Ethernet adapter
Replacing an mLOM Ethernet adapter
Procedure
1. Power off the server. For more information, see "Powering off the server."
2. Disconnect cables from the Ethernet adapter.
3. Loosen the captive screws and then pull the Ethernet adapter out of the slot, as shown in Figure
135.
Figure 135
Removing an mLOM Ethernet adapter
4. Install a new mLOM Ethernet adapter. For more information, see "Installing an mLOM Ethernet
adapter."
5. Connect cables for the mLOM Ethernet adapter.
6. Power on the server. For more information, see "Powering on the server."
Verifying the replacement
Log in to HDM to verify that the mLOM Ethernet adapter is in a correct state. For more information,
see HDM online help.
Replacing a PCIe Ethernet adapter
WARNING!
To avoid bodily injury from hot surfaces, allow the server and its internal modules to cool before
touching them.
To Next Page
Loading...
