13
Figure 7 Connecting a USB device to an internal USB connector
3. (Optional.) Install the access panel. For information about how to install the access panel, see
"Installing the access panel."
4. Verify that th
e server can identify the USB device.
If the server fails to identify the USB device, download and install the driver for the USB device.
If the server still fails to identify the USB device after the driver is installed, replace the USB
device.
Connecting the power cord
Guidelines
WARNING!
To avoid damage to the equipment or even bodily injury, use the power cord that ships with the
server.
Before connecting the power cord, make sure the server and components are installed correctly.
Procedure
1. Insert the power cord plug into the power receptacle of a power supply at the rear panel, as
shown in Figure 8.
To Next Page
Loading...
