Haas VF Series Service Manual

96-8100 1-15-96
224
CABLE LIST
HAAS AUTOMATION, INC.
SERVICE MANUAL
VF-SERIES
520 RELAY CARD 2 DRIVE CABLE - 16 WIRE RIBBON #24
530 RELAY CARD 3 DRIVE CABLE - 16 WIRE RIBBON #24
540 RELAY CARD 4 DRIVE CABLE - 16 WIRE RIBBON #24
550 INPUTS CARD CABLE (MOTIF-P10) 34 WIRE RIBBON #24
560 TO MICROPROCESSOR P8 (REMOVED NOV-94)
561 -12V FROM 862 AT SUPPLY TO P8-1 #24
562 Gnd FROM 865 AT SUPPLY TO P8-4 #24
570 X AXIS DRIVER LOW VOLTAGE POWER - 6 WIRE RIBBON
571 14 VAC LEG 1 (DRIVER P2-1 #24
572 14 VAC LEG 2 (DRIVER P2-2 #24
573 16 VAC LEG 1 (DRIVER P2-3 #24
574 16 VAC LEG 2 (DRIVER P2-4 #24
575 CHASSIS GROUND (DRIVER P2-5 #24
576 CHASSIS GROUND (DRIVER P2-6 #24
580 Y AXIS DRIVER LOW VOLTAGE POWER (LATHE T.S)
(SAME AS 571 to 576)
590 Z AXIS DRIVER LOW VOLTAGE POWER
(SAME AS 571 to 576)
600 A AXIS DRIVER LOW VOLTAGE POWER
(SAME AS 571 to 576)
610 X AXIS DRIVER CONTROL CABLE - SHIELD +6
611 LOW ENABLE* (MOTIF P2-1) #24
612 HIGH ENABLE* (MOTIF P2-2) #24
613 DRIVE DIRECTION (MOTIF P2-3) #24
614 +5 VDC (MOTIF P2-4) #24
615 OVERCURRENT SIGNAL (MOTIF P2-5) #24
616 LOGIC RETURN (MOTIF P2-6) #24
620 Y AXIS DRIVER CONTROL CABLE - SHIELD +6 (LATHE T.S)
(SAME AS 611-616)
630 Z AXIS DRIVER CONTROL CABLE - SHIELD +6
(SAME AS 611-616)
640 A AXIS DRIVER CONTROL CABLE - SHIELD +6
(SAME AS 611-616)
650 THREE PHASE POWER TO SPINDLE MOTOR - SHIELD +3
651 LEG 1 OF 230VAC #14
652 LEG 2 #14
653 LEG 3 #14

Haas VF Series Specifications

General

Machine Type	Vertical Machining Center
Control	Haas CNC Control
Z-Axis Travel	20-30 inches (varies by model)
Y-Axis Travel	16 - 30 inches (varies by model)
Spindle Motor	20-30 hp (depending on model)
Tool Capacity	20-40 tools (varies by model)