Haas VF Series Service Manual

1-15-96 96-8100
HAAS AUTOMATION, INC.
225
TABLE OF CONTENTS
CABLE LIST
VF-SERIES
SERVICE MANUAL
660 X-ENCODER CABLE - SHIELD +7
661 LOGIC RETURN (D GROUND) #24
662 ENCODER A CHANNEL #24
663 ENCODER B CHANNEL #24
664 +5 VDC #24
665 ENCODER Z CHANNEL #24
666 HOME/LIMIT SW #24
667 OVERHEAT SWITCH #24
668 ENCODER A*
669 ENCODER B*
66T ENCODER Z*
670 Y-ENCODER CABLE - SHIELD +7 (LATHE SPINDLE ENCODER)
(SAME AS 661-66T)
680 Z-ENCODER CABLE - SHIELD +7
(SAME AS 661-66T)
690 A-ENCODER CABLE - SHIELD +7
(SAME AS 661-66T)
700 KEYBOARD CABLE - 34 WIRE RIBBON WITH IDC
(FROM VIDEO P4 TO KBIF P1)
710 FORWARD/REVERSE/RESET TO SPINDLE - SHIELD +4
711 FORWARD COMMAND (SP DR CN1-18 TO IO P9-4) #24
712 REVERSE COMMAND (CN1-19 TO IO P9-3) #24
713 RESET COMMAND (CN1-21 TO IO P9-2) #24
714 COMMON (CN1-14 TO IO P9-1) #24
720 ANALOG SPEED COMMAND TO SPINDLE - SHIELD +2
721 0 TO +10 VOLTS SPEED COMMAND (SPINDLE DRIVE CN1-1) #24
722 SPEED COMMAND REFERENCE (A GROUND) (CN1-17) #24
730 POWER METER FROM SPINDLE DRIVE TO KBIF - SHIELD +2
731 METER + (SPINDLE DRIVE CN1-5 TO KBIF) #24
732 METER - (CN1-6 TO KBIF) #24
730A POWER METER FROM KBIF TO METER - SHIELD +2
733 METER + AFTER TRIM POT (KBIF TO METER) #24
734 METER - AFTER TRIM POT (KBIF TO METER) #24
730B ANALOG SIGNAL FROM SPINDLE DRIVE LOAD MONITOR
731 SIGNAL 0..5V
732 GROUND
740 POWER ON/OFF CABLE TO FRONT PANEL - SHIELD +4
741 POWER ON SWITCH LEG 1 (24 VAC) #24
742 POWER ON SWITCH LEG 2 #24 N.O.
743 POWER OFF SWITCH LEG 1 (24 VAC) #24
744 POWER OFF SWITCH LEG 2 #24 N.C.

Haas VF Series Specifications

General

Machine Type	Vertical Machining Center
Control	Haas CNC Control
Z-Axis Travel	20-30 inches (varies by model)
Y-Axis Travel	16 - 30 inches (varies by model)
Spindle Motor	20-30 hp (depending on model)
Tool Capacity	20-40 tools (varies by model)