Haas VF Series Service Manual

96-8100 1-15-96
226
CABLE LIST
HAAS AUTOMATION, INC.
SERVICE MANUAL
VF-SERIES
750 JOG-CRANK DATA CABLE - SHIELD +4
751 LOGIC RETURN (D GROUND) (65) #24
752 ENCODER A CHANNEL #24
753 ENCODER B CHANNEL #24
754 +5 VDC #24
760 MONITOR VIDEO DATA CABLE - SHIELD +9 (all #24)
(FROM VIDEO P3 TO CRT)
770 EMERGENCY STOP INPUT CABLE - SHIELD +2
771 SIGNAL (INPUT 8) #20
772 RETURN (D GROUND) (65) #20
770A SECOND E-STOP INPUT FOR HORIZONTAL
780 STATUS CABLE FROM SPINDLE DRIVE - SHIELD +4
781 +12 VDC (SPINDLE DRIVE CN1-25) #24
782 FAULT (INPUT 18 TO CN1-24) #24
783 AT SPEED (INPUT 20 TO CN1-23) #24
784 STOPPED (INPUT 19 TO CN1-22) #24
790 SPARE INPUTS FROM IOPCB P24
791 SPARE 1
792 SPARE 2
793 COMMON
800 12VAC TO LAMP - SHIELD +2
801 UNSWITCHED LEG 1 #20
802 SWITCHED LEG 2 #20
800A CABLE FOR LAMP SWITCH - SHIELD +2
800B CABLE WITH 10VAC FROM TRANSFORMER T2 - SHIELD +2
810 TOOL CHANGER MOTORS - SHIELD +2 #20
811 TURRET MOTOR + (IO P30-2 TO P6-J) #14
812 TURRET MOTOR - (IO P30-1 TO P6-I) #14
810A TOOL CHANGER MOTORS - SHIELD +2 #20
813 SHUTTLE MOTOR - (IO P30-4 TO P6-A) #14
814 SHUTTLE MOTOR + (IO P30-3 TO P6-B) #14
820 TOOL CHANGER STATUS - SHIELD +7
821 LOGIC RETURN (D GROUND) (P6-F/H/L/M) #24
822 GENEVA MARK (INPUT 5 TO P6-G) #24 (LATHE PART DOOR)
823 TOOL #1 (INPUT 3 TO P6-E) #24
824 SHUTTLE IN (INPUT 1 TO P6-C) #24 (LATHE TURRET CLAMPED)
825 SHUTTLE OUT (INPUT 2 TO P6-D) #24 (LATHE TURRET UNCLAMPED)
830 OVERHEAT THERMOSTAT - SHIELD +2

Haas VF Series Specifications

General

Machine Type	Vertical Machining Center
Control	Haas CNC Control
Z-Axis Travel	20-30 inches (varies by model)
Y-Axis Travel	16 - 30 inches (varies by model)
Spindle Motor	20-30 hp (depending on model)
Tool Capacity	20-40 tools (varies by model)