HIKVISION DS-K1T804A Series - Page 9

equipment installaon on vibraons surface or places subject
to shock (ignorance can cause equipment damage).
•
Do not place the device in extremely hot (refer to the
specicaon of the device for the detailed operang
temperature), cold, dusty or damp locaons, and do not
expose it to high
electromagnec radiaon.
•
The device cover for indoor use shall be kept from rain and
moisture.
•
Exposing the equipment to direct sun light, low venlaon or
heat source such as heater or radiator is forbidden (ignorance
can cause
re danger).
•
Do not aim the device at the sun or extra bright places. A
blooming or smear may occur otherwise (which is not a
malfuncon however), and aecng the endurance of sensor
at the same
me.
•
Please use the provided glove when open up the device cover,
avoid direct contact with the device cover, because the acidic
sweat of the ngers may erode the surface coang of the
device cover.
•
Please use a so and dry cloth when clean inside and outside
surfaces of the device cover, do not use alkaline detergents.
•
Please keep all wrappers aer unpack them for future use. In
case of any failure occurred, you need to return the device to
the factory with the original wrapper.
Transportaon without
the original wrapper may result in damage on the device and
lead to
addional costs.
•
Improper use or replacement of the
baery may result in
hazard of explosion. Replace with the same or equivalent type
only. Dispose of used baeries according to the instrucons
provided by the baery manufacturer.
•
You can view the device License via the website: hp://
opensource.hikvision.com/Home/List?id=46
.
viii