HIKVISION DS-K1T804A Series - Page 95

Work Hour Rate is used to calculate work hours by
mulplying it by overme. When you work for a certain
period aer end-work me on workday, you will reach
dierent overme level. You can set dierent work hour
rates (1-10, can be a decimal) for three overme levels. For
example, your valid overme is one hour (in overme level
1), and the work hour rate of
overme level 1 is set as 2,
then the work hours in the period will be calculated as 2
hours.
Overme Rule for Weekend
You can enable
overme rule for weekend and set
calculaon mode.
3.
Click Save.
Congure Aendance Check Point
You can set the card reader(s) of the access point as the
aendance check point, so that the authencaon on the card
readers will be recorded for aendance .
Before You Start
You should add access control device before conguring
aendance
check point. For details, refer to Add Device.
Steps
Note
By default, all card readers of the added access control devices
are set as aendance checkpoint.
1.
Enter the Time & Aendance module.
2.
Click Aendance Sengs → Aendance Check Point to enter
the Aendance Check Point Sengs page.
3.
Oponal: Set Set All Card Readers as Check Points switch to
o.
Only the card readers in the list will be set as the aendance
check points.
4.
Check the desired card reader(s) in the device list as
aendance check point(s).
5.
Set check point
funcon as Start/End-Work, Start-Work or
End-Work.
6.
Click Set as Check Point.
The
congured aendance check point displays on the right
list.
Congure Holiday
You can add the holiday during which the check-in or check-out
will not be recorded.
Add Regular Holiday
You can congure a holiday which will take eect annually on
regular days during the
eecve period, such as New Year's Day,
Independence Day, Christmas Day, etc.
Steps
1.
Enter the Time &
Aendance module.
2.
Click
Aendance Sengs → Holiday to enter the Holiday
Sengs page.
3.
Check Regular Holiday as holiday type.
80