Hioki 3560 - Operating Procedure (GP-IB); Communication Methods by the GP-IB; Program Messages

103
────────────────────────────────────────────────────
8.2 Operating Procedure (GP-IB)
────────────────────────────────────────────────────
1
2
3
4
5
6
7
8
9
10
11
12
13
14
A
8
.2.1 Communication Methods by the GP-IB
Program messages
Response message
s
Command message
s
Query messages
Message
s
8
.2.2 Program Messages
8
.2 Operating Procedure (GP-IB)
In order to control the 3560 by the GP-IB, there are several kinds of
messages. Of these, program messages are those received by the 3560
from the computer, while response messages are those sent from the 3560
to the computer.
Program messages are command messages or query messages.
(1) Command messages
Command messages are orders for controls of the 3560, such as for
making measurement condition settings or for reset or the like.
Example :LIM ON
(2) Query messages
Query messages are order for responses relating to results of
measurement, or the state of 3560 settings. (A question mark"?"is
suffixed at the end of the command.)
Example :CSET:BEEP?