Hioki 3560 - Chapter 11 Maintenance and Service; Message Code Table

133
────────────────────────────────────────────────────
11.1 Message Code Table
────────────────────────────────────────────────────
1
2
3
4
5
6
7
8
9
10
1
1
12
13
14
15
This message appears whenever the 3560 is
turned on, and indicates the model name and
the software version.
Zero adjust error
This message indicates that the measured
value is out of range in the zero-adjustment
mode.
See Section 4.4 "Zero Adjust"
EEPROM error
This message appears whenever the 3560 is
turned off or data is not correctly written due
to a faulty EEPROM while the measurement
conditions are being set in the EEPROM of the
3560.Contact your dealer or Hioki
representative.
System error
The ROM or RAM of the 3560 is faulty.Contact
your dealer or Hioki representative.
This message indicates that Hioki’s adjustmen
t
program is active. When this message appears
,
immediately turn off the 3560 and turn it on
again. If you continue to operate the keys
without initiating this reboot sequence, the
corrected data will be lost and consequently th
e
3560 will not work correctly.
Chapter 1
1
Maintenance and Servic
e
1
1.1 Message Code Table
The following messages appear on the display of the 3560.