Hioki 3560 - Message Code Table; Common Command

63
────────────────────────────────────────────────────
7.3 Message Code Table
────────────────────────────────────────────────────
7
.3.1 Common Command
Command
Input/outpu
t
data forma
t
Meaning
*CLS
Clears the status byte register and the event
registers.
*ESE
Numerical
value (1)
Sets the standard event status enable
register.
*ESE? NR1 (1)
Queries out and clears the contents of the
standard event status register (SESR).
*ESR? NR1 (1)
Queries out and clears the contents of the
standard event status register (SESR).
*IDN?
[HIOKI,356
0
,0,V
*
.
**
]
Queries device ID.
*OPC
Sets the standard event status register bit0
(OPC bit) to "1."
*OPC? NR1 (1)
Returns a "1" instead of setting the SESR
bit0 (OPC bit) to "1."
*RST
Initializes the settings.
*SRE
Numerical
value (1)
Sets the service request enable register
(SRER).
*SRE? NR1 (1)
Queries the service request enable register
(SRER).
*STB? NR1 (1)
Queries the status byte register.
*TRG
Request for sampling
*TST? NR1 (1)
Requests execution of, and queries the result
of, the self test.
*WAI
Waits until sampling is fully completed.
7
.3 Message Code Table
( ) indicates the number of data.