Hioki 3560 - Setting the Power Supply Frequency

15
────────────────────────────────────────────────────
3.5 Setting the Power Supply Frequency
────────────────────────────────────────────────────
1
2
3
4
5
6
7
8
9
10
11
12
13
14
A
Blinkin
g
NOTE
3
.5 Setting the Power Supply Frequency
1. Press the SHIFT key. "SHIFT" appears lit in the
display.
2. Press the
VIEW (50/60 Hz) key. The power supply
frequency setup screen appears as shown to the
left, with the current frequency flashing.
3. Press the
+ and keys to select the power
supply frequency. The selected frequency will
flash.
4. Press the
ENTER key to set the selected power
supply frequency. The system returns to
measurement mode.
Failure to set the correct power supply frequency will prevent accurate
measurement. Make sure the correct frequency is set.