Hioki 3560 - Safety Notes

ii
────────────────────────────────────────────────────
Safety Notes
────────────────────────────────────────────────────
WARNIN
G
This instrument is designed to comply with IEC 61010 Safety
Standards, and has been thoroughly tested for safety prior to
shipment. However, mishandling during use could result in injury or
death, as well as damage to the instrument. Be certain that you
understand the instructions and precautions in the manual before
use. We disclaim any responsibility for accidents or injuries not
resulting directly from instrument defects.
Safety symbols
･ The symbol printed on the instrument indicates that the user
should refer to a corresponding topic in the manual (marked with
the
symbol) before using the relevant function.
･ In the manual, the
symbol indicates particularly important
information that the user should read before using the instrument.
Indicates AC (Alternating Current).
Indicates DC (Direct Current).
Indicates the ON side of the power switch.
Indicates the OFF side of the power switch.
DANGE
R
Indicates that incorrect operation presents an extreme hazard that
could result in serious injury or death to the user.
WARNIN
G
Indicates that incorrect operation presents a significant hazard that
could result in serious injury or death to the user.
CAUTIO
N
Indicates that incorrect operation presents a possibility of injury to
the user or damage to the instrument.
NOTE
Indicates advisory items related to performance or correct operation
of the instrument.
S
afety Notes
This manual contains information and warnings essential for safe
operation of the instrument and for maintaining it in safe operating
condition. Before using the instrument, be sure to carefully read the
following safety notes.
The following symbols in this manual indicate the relative importance of
cautions and warnings.