Hioki 3560 - Messages

64
────────────────────────────────────────────────────
7.3 Message Code Table
────────────────────────────────────────────────────
7
.3.2 Messages
Command
Input/output
Data format
Meaning
:ADJust?
Executes zero-adjust and queries the
result.
:AUTorange [ON/OFF] (1)
Sets the auto range.
:AUTorange? [ON/OFF] (1)
Queries for auto-range mode on/off
status.
:COMParator Numerical value (1)
Selects the comparator to be used.
:COMParator? NR1 (1)
Queries the comparator number.
:CSET:BEEPer
[OFF/IN/HI] (1)
[OFF/PASS/FAIL] (1)
Sets the buzzer for comparator
determination.
:CSET:BEEPer?
[OFF/IN/HI] (1)
[OFF/PASS/FAIL] (1)
Queries the buzzer setting for
comparator.
:CSET:MODe [R/RV] (1)
Sets for the measurement mode set
for the comparator.
:CSET:MODe? [R/RV] (1)
Queries for the measurement mode
set for the comparator.
:CSET:NUMBer Numerical value (1)
Selects the number of comparator to
be set.
:CSET:NUMBer? NR1 (1)
Queries the number of comparator to
be set.
:CSET:RPARameter Numerical value (2)
Sets the upper and lower limits for
comparator resistance.
:CSET:RPARameter? NR3 (1)
Queries the upper and lower limits
for comparator resistance.
:CSET:RRANge Numerical value (1)
Sets the resistance range used by th
e
comparator.
:CSET:RRANge? NR3 (1)
Sets the resistance range used by th
e
comparator.
:CSET:VPARameter Numerical value (2)
Sets for the comparator voltage uppe
r
and lower limits.
:CSET:VPARameter? NR3 (2)
Queries for the comparator voltage
upper and lower limits.
:CSET:VRANge Numerical value (1)
Sets for the voltage range used by
the comparator.
:CSET:VRANge? NR3 (1)
Queries for the voltage range used b
y
the comparator.
:CTMode [AUT/MAN]
Sets the comparator mode.
:CTMode? [AUT/MAN]
Queries the comparator mode.
:FREQuency Numerical value (1)
This command sets power supply
voltage.
:FREQuency? NR1 (1)
This command queries power supply
voltage.
:HEADer [ON/OFF] (1)
Enable and disable headers.
:HEADer? [ON/OFF] (1)
Queries the headers enablement.
:HOLD [ON/OFF] (1)
Sets the measurement hold.