65
────────────────────────────────────────────────────
7.3 Message Code Table
────────────────────────────────────────────────────
:HOLD? [ON/OFF] (1)
Queries for the hold-mode on/off
status.
:LIMit [ON/OFF] (1)
Queries for set open-circuit terminal
voltage.
:LIMit? [ON/OFF] (1)
Queries for set open-circuit terminal
voltage.
:LOCK:EXTernal [ON/OFF] (1)
This command turns external input
terminal locking on or off.
:LOCK:EXTernal? [ON/OFF] (1)
Response Format for Query that
Returns Numeric Data
:LOCK:KEY [ON/OFF] (1)
Sets the key lock.
:LOCK:KEY? [ON/OFF] (1)
Queries for the on/off status of the
key lock.
:MEASure:BATTery?
NR3 (2)
[FAIL/PASS/OFF/NG] (1
Queries for the current measured
resistance and voltage and
comparator result.
:MEASure:RESistance
NR3
[HI/IN/LO/OFF/NG] or
[FAIL/PASS/OFF/NG] (1
Queries for the current measured
resistance and comparator result.
:MEASure:VOLTage? NR3
Queries for the current measured
voltage and comparator result.
:MODe [R/RV] (1)
Sets the measurement mode.
:MODe? [R/RV] (1)
Queries the measurement mode.
:RRANge Numerical value (1)
Sets the resistance range.
:RRANge? NR3 (1)
Queries the resistance range.
:SAMPle [FAST/MED/SLOW] (1)
Sets the sampling rate.
:SAMPle? [FAST/MED/SLOW] (1)
Queries the sampling rate.
:SENSecheck [ON/OFF] (1)
Sets the SENSE line break check for
measurement leads.
:SENSecheck? [ON/OFF] (1)
Queries on/off status of the SENSE
line break check for measurement
leads.
:VRANge Numerical value (1)
Sets the voltage range.
:VRANge? NR3 (1)
Queries the voltage range.
:ZERoclear
Excuses zero clear.
To Next Page
Loading...
