Hioki 3560 - Printing

121
────────────────────────────────────────────────────
9.3 Printing
────────────────────────────────────────────────────
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
9
.3 Printing
This section explains how to output data to a general-purpose Centronics
printer. Measure the resistance or resistance and voltage. For
measurement methods, see Chapter 4 "Measurement Procedure."
Change the PRINT (print trigger) of the external control terminal from
"H" to "L." For more information on this, see Chapter 6 "External Control
Terminal and External Output Terminal." On receiving the print trigger
signal from the external control terminal, the printer outputs the
measured values and comparator result as follows:
■Printing example