Hioki 3560 - Page 6

Chapter 9 Printer Interface (Option) 119
9.1 Outline
119
9.2 Connection with a General-purpose Centronics
Printer
119
9.3 Printing 121
Chapter 10 Useful Information and Advanced
Measurement 123
10.1 AC Four-terminal Method
123
10.2 Synchronous Detection System 124
10.3 Configuration and Extension of the Measurement
Leads
125
10.4 Effect of Over-voltage 127
10.5 SOURCE/SENSE Line Break Check 128
10.6 IEC 512-2, JIS C 5402 and JIS C 5441 129
10.7 Example of Advanced Measurements 130
10.8 Calibration of the 3560 131
Chapter 11 Maintenance and Service 133
11.1 Message Code Table 133
11.2 Cleaning 134
11.3 Troubleshooting 135
11.4 Options 136
11.4.1 9588 GP-IB INTERFACE 136
11.4.2 9589 PRINTER INTERFACE 136
11.4.3 9203 DIGITAL PRINTER 136
11.4.4 9287-10 CLIP TYPE LEAD (Option) 137
11.4.5 9452 CLIP TYPE LEAD 137
11.4.6 9453 FOUR TERMINAL LEAD 138
11.4.7 9455 PIN TYPE LEAD 138
11.4.8 9461 PIN TYPE LEAD 139
11.4.9 9467 LARGE CLIP TYPE LEAD 139
11.4.10 9454 ZERO ADJUSTMENT BOARD 139
11.4.11 9466 REMOTE CONTROL SWITCH 140