Assembly and Commissioning Instructions Servo amplifier D1-N 15.10.2015
The following safety notices must be observed. Non-compliance with safety
notices may put life and limb at risk.
• The drive amplifiers should be de-energised before and during all assem-
bly, disassembly or repair work. Ensure that no-one can re-establish the
mains connection. Otherwise there is a risk of death and injury.
• Discharge your body before you touch the drive amplifier.
•
Avoid contact with highly insulating materials (plastic fibres, plastic films
etc.). Place the drive amplifier on a conductive surface. The drive amplifi-
ers contain components at risk from electrostatic which may
if handled incorrectly.
• The drive amplifiers must not be used in areas at risk of explosion.
• The drive amplifiers may only be used and operated indoors.
• The drive amplifiers should always be operated in conjunction with appro-
priate safety equipment (zero-
contact protective equipment, mechanical
protective equipment etc.). This protective equipment must be designed,
installed and regularly checked in accordance with applicable national
and international legislation and specifications.
Safety notices regarding storing the drive amplifiers
The drive amplifiers are delivered in packaging. If the drive amplifiers are to
be put into storage, they must be kept in this packaging. They must be stored
in a dry location with protection from impact.
Safety notices regarding transporting the drive amplifiers
Drive amplifiers may only be transported by qualified staff in the original re-
cyclable packaging. Severe impact should be avoided and the following ambi-
ent conditions should be observed:
• Permissible temperature during transport:
–20 to +65 °C, max. 20 K/hour fluctuating
• Permissible air humidity during transport:
relative humidity 20 % to 85 %, non-condensing
To Next Page
Loading...
Need help?
General