8 / 183
Assembly and Commissioning Instructions Servo amplifier D1-N
These assembly and commissioning instructions must be available at all times to
everyone working with or on the D1-N servo drive amplifier.
Scope of validity for these assembly and commissioning instructions
These assembly and commissioning instructions apply to servo drive amplifiers
from HIWIN with the following product designations:
• D1-N-09-xx-x-x-xx
• D1-N-18-xx-x-x-xx
• D1-N-36-xx-x-x-xx
• D1-N-90-xx-x-x-xx
They also apply if two or more of the drive amplifiers listed above are combined.
Depiction of safety notices
Safety notices are always indicated using a signal word and sometimes also a sym-
bol for the specific risk (see section 1.7).
The following signal words and risk levels are used in these instructions:
Non-compliance with the safety notices will result in serious injury or death!
Potentially dangerous situation!
Non-compliance with the safety notices runs the risk of serious injury or death!
Potentially dangerous situation!
Non-compliance with the safety notices runs the risk of moderate to slight injury!
Potentially dangerous situation!
Non-compliance with the safety notices runs the risk of damage to property or
To Next Page
Loading...
Need help?
General