Hiwin D1-N Series - X1 - Mains Connection; 1-Phase Mains Connection with Mains Filter

Assembly and Commissioning Instructions Servo amplifier D1-N  15.10.2015
29 / 183
5.2
X1 – mains connection
The minimum cross-section of the mains connection cable depends on local re-
quirements (see VDE 0100 Part 523, VDE 0298 Part 4), the ambient temperature
and the rated current required of the drive amplifier.
Pin
Name
1
L3
2
PE
3
L2 (N)
4
L1
Table 5.1: X1 – mains connection
The D1-N does not have an integrated mains filter. A suitable mains filter (not in-
cluded in scope of supply) must therefore be provided in order to operate the drive
amplifier. A distinction is made between the single- and three-phase mains con-
nection on the D1-N.
5.2.1
1-phase mains connection with mains filter
Figure 5.3: 1-phase mains filter
HIWIN recommends the mains filter described in Table 5.2 for the D1-N's 1-phase
mains connection.