Assembly and Commissioning Instructions Servo amplifier D1-N 15.10.2015
Open “Advanced” menu and select “PDL task list…”.
Figure 10.7: “PDL task list…” in “Lightening” selection
If “Run” is displayed in the “State” column of the individual tasks, the saved pro-
gram is running in the D1-N.
Figure 10.8: “Task List” in “Lightening” selection
Stopping PDL program, allowing it to run on and deleting it
The “Lightening” software has an input window called “Message window” under
“Performance center” for stopping a PDL program.
Figure 10.9: Calling up the „Message window“
To Next Page
Loading...
Need help?
General