Turn the jack dial (wheel nut
wrench) clockwise as shown to
raise the vehicle until the flat tire
is off the ground.
Put on the spare tire. Put the
wheel nuts back on finger-tight,
then tighten them in a crisscross
pattern with the wheel nut wrench
until the wheel is firmly against
the hub. Do not try to tighten the
wheel nuts fully.
Lower the vehicle to the ground,
and remove the jack.
Before mounting the spare tire,
wipeanydirtoffthemounting
surface of the wheel and hub with
a clean cloth. Wipe the hub
carefully;itmaybehotfrom
driving.
16. 17.
18.
19.
CONTINUED
Changing a Flat Tire
Taking Care of the Unexpected
617
BRAKE HUB
11/08/01 11:11:18 31SZA630_624
To Next Page
Loading...
