This indicator normally comes on for
a few seconds when you turn the
ignition switch to the ON (II)
position.
This indicator normally comes on for
a few seconds when you turn the
ignition switch to the ON (II)
position. For more information, see
page .
The left or right turn signal indicator
blinks when you signal a lane change
or turn. If an indicator does not blink
or blinks rapidly, it usually means
one of the turn signal bulbs is
burned out (see page ). Replace
the bulb as soon as possible, since
other drivers cannot see that you are
signaling.
When you press the hazard warning
button, both turn signal indicators
and all turn signals on the outside of
the vehicle flash.
Itcomesonasareminderthatyou
have turned off the vehicle stability
assist (VSA) system.
It flashes when VSA is active (see
page ).
Ifitcomesonandstaysonatany
other time, there is a problem with
the VSA or Hill Start Assist system.
Take your vehicle to a dealer to have
it checked. Without VSA, your
vehicle still has normal driving ability,
but will not have VSA traction and
stability enhancement. See page
for more information on the
VSA system.
You will also see a ‘‘CHECK VSA
SYSTEM’’ message on the multi-
information display (see page
).
You will also see a ‘‘CHECK VSA
SYSTEM’’ message on the multi-
information display (see page ).
93
93
533
533
533
587
On Touring models
On Touring models
Instrument Panel Indicators
Vehicle Stability Assist
(VSA) System Indicator
Turn Signal and
Hazard Warning
Indicators
VSA OFF Indicator
Instruments and Controls
71
11/08/01 08:28:26 31SZA630_078
To Next Page
Loading...
